TRICKY

TRICKED-OUT HANDLEBAR SWITCH CONTROL

TRICKY

A unique 2-button, multi-function do it all handlebar switch controller for signal lights, headlight low/high beams, horn and starter. The controller, for that custom project without sacrificing functionality.

  • Simple tap functions for ease of operations
  • Works with any momentary type switch
  • On board flasher and power outputs for all functions
  • Small form factor for a clean install
  • All digital operation
  • Simple screw terminal for easy hookup
  • 6/12 volt compatible
  • Built in protections
  • 2 year replacement warranty

*Do not over torque screw terminals, solder wire tips for secure connections*

  1. Determine a mounting location for unit (keep away from heat, water does not affect unit)
  2. Connect “key” power (+) also known as “ignition” power (+) to Tricky screw terminal pin 1
  3. Connect a “ground” (-) wire to Tricky screw terminal pin 2
  4. Connect momentary switch 1 (-) to Tricky screw terminal pin 3
    ** 1 side of switch to “ground” other side to Tricky **
  5. Connect momentary switch 2 (-) to Tricky screw terminal pin 4
    ** 1 side of switch to “ground” other side to Tricky **
  6. Connect right signal light (+) to Tricky screw terminal pin 5
  7. Connect left signal light (+) to Tricky screw terminal pin 6
  8. Connect headlight low (+) to Tricky screw terminal pin 7
  9. Connect headlight high (+) to Tricky screw terminal pin 8
  10. Connect starter solenoid (+) to Tricky screw terminal pin 9
  11. Connect horn (+) to Tricky screw terminal pin 10
  12. Turn bike on to test functionality
  13. 1 tap of switch 1, right turn signal (ON), 1 tap, (OFF)
    2 quick tap of switch 1, headlight low (ON), 2 quick tap (OFF)
    Hold switch 1, starter (ON), release (OFF)
    1 tap of switch 2, left turn signal (ON), 1 tap, (OFF)
    2 quick tap of switch 2, headlight high (ON), 2 quick tap (OFF)
    Hold switch 2, horn (ON), release (OFF)
  14. Bundle wires and mount unit

 

Scroll to Top